The charger design allows for a much smoother charge and mugs will charge quicker than the standard chargers. Also there is less likelihood of a mug not charging when placed slightly off centre as the sides are higher and are better at guiding the mug onto the pins. They also have a much smaller footprint and take up less desk or surface space.
 
The coasters are made of 3d printed parts and other components sourced from manufacturers.
The chargers are compatible with all Ember Travel Mugs and Mugs.
The coaster has a power switch so once the mug is fully charged you can switch off both the coaster and mug, and still store the mug on the coaster and not waste electricity.
Low cost alternative to an Ember Charger.
All Mugs 1st and 2nd Gen are supported.
The coasters are very stable and the mugs naturally sit in them and charge immediately on contact.
The charger base is compatible with PD2 or PD3 chargers of at least 30W and an ouput of 20V.
 
The USB-C Chargers I sell are currently selling for £25 on Amazon and I am selling them at a huge discount alongside the coasters, please be sure your charger supports 20V and 1.5amps before you purchase a charger. These chargers will very likely not work connected to a standard car. laptop or pc port as they will only support max 12v. If you are not sure then please send me a photo of the power sticker on the device.
If you are looking for a specific colour please drop me a message and I will see if I can accomodate you.